Set Recording Calling Search Space to the CSS that includes partitions containing the user phones and the partition that you set up for the MiaRec SIP Trunk. Make sure it does not collide with your numbering plan. No user is going to directly call this number, this is internal to the system. The only guideline for this number: it should be possible for UCM to route it to the SIP trunk where the recorder is defined. Set Recording Destination Address to the directory number that associates the recorder with this recording profile. The following figure illustrates creating a recording profile. Use the Device > Device Settings > Recording Profile menu option in Cisco Unified Communications Manager Administration to create recording profile. Not only is it not helpful, but it can result in unnecessary failure recovery delays. However, in single-node deployments, SIP Options Ping is not recommended. The SIP Options Ping feature allows to detect availability of the recording server earlier, without having to wait until a call is ready to be recorded. It skips that server in the round-robin or sequential list of recording servers. If the recording server is unavailable вЂ“ indicated by either no response, response of вЂњ408 Request TimeoutвЂќ response of вЂњ503 Service UnavailableвЂќ, Cisco UCM marks this recording server as unavailable. Cisco UCM periodically sends a SIP OPTIONS (ping) message to each recording server to detect its availability.

Multi-server setup - enable SIP OPTIONS PingД¬isco UCM starting from v.8.5(1) supports SIP OPTIONS Ping feature.

Single-server setup - disable SIP OPTIONS Ping.

In a single-server setup, this feature should be disabled (see details below). In multi-server setup, it is recommended to enable SIP Options Ping feature for each recording server.

Check the Deliver Conference Bridge Identifier check box on the remote cluster SIP profile as well.Д¬hecking this check box is not required for recording, but the conference bridge identifier helps to group multiple call segments belonging to the same conference into one interaction, like shown in below screenshot: If the check box is left unchecked, the far-end information for the remote conference remains empty. When enabled it allows to deliver additional information (specifically, the b-number that identifies a conference bridge) to the recorder across the SIP trunk.

Make sure that the Deliver Conference Bridge Identifier option is checked.

The following figure illustrates creating a SIP profile for the recorder. Use the Device > Device Settings > SIP Profile menu option in Cisco Unified Communications Manager Administration to create SIP profile for recorder.

Sip trunk setup trix box setup